qmk_firmware_2/keyboards/fruitykeeb/fruitbar/readme.md

Fruitbar

A budget-oriented 40% with base kit compatibility. Perfect for those who have always wanted to try a 40% but worried about the lack of punctuation and arrow keys.

• Keyboard Maintainer: The QMK Community
• Hardware Supported:
  • Fruitbar PCB R1 (atmega32u4)
    • If the keyboard was built with an Elite-C, use the fruitykeeb/fruitbar/r1/elite_c firmware for RGB and encoder support.
  • Fruitbar PCB R2 (RP2040, rp2040)
• Hardware Availability:
  • R1 Group Buy took place between 2021-10-01 and 2021-10-24 on FruityKeeb.
  • R2 Group Buy took place between 2023-02-01 1400 UTC and 2023-03-04 0359 UTC on P3DStore(US), 42keebs.eu(EU), CustomKBD(AU).

Make example for this keyboard (after setting up your build environment):

make fruitykeeb/fruitbar/r1:default
make fruitykeeb/fruitbar/r2:default

Flashing example for this keyboard:

make fruitykeeb/fruitbar/r1:default:flash
make fruitykeeb/fruitbar/r2:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the top left key and plug in the keyboard. This will also clear EEPROM/emulated EEPROM, so it is a good first step if the keyboard is misbehaving.
• Physical reset:
  • R1: Short the RST and GND pins on the Pro Micro.
  • R2: While holding down the Boot button, press the Reset button.
• Keycode in layout: Press the key mapped to QK_BOOT. In the default keymap it is on the second layer, replacing the Left Control key in the bottom left.